Jump to content

Blood Angels Blood Chalice conversion


Remtek

Recommended Posts

The chalice is to large if your going for scale, but it's simple and does not require greenstuff.

 

I did not take pictures of the whole process, but it should be pretty straightforward :drool:

 

Parts you need:

2 standard marine shoulderpads.

Sword arm bit, or equivalent.

Meltabomb

1mm thick paperclip (optional)

 

 

- Glue the shoulderpads together, this will be the main cup

- Cut off the top of a meltabomb, this will be the botton part

 

(Optional pinning) Drill holes through the middle of both top and botton bit and drill a hole through his hand, put some glue in the holes and run the whole pin through all 3 parts.

 

 

http://www.remtek.be/chalice.png

Link to comment
Share on other sites

Great minds think alike ;)

 

Did this a couple of years ago in much the same way, but I do think it would look better if you cut off the vertical trim on the shoulderpad.

 

Also you can then fill it with PVA glue mixed with red ink and then give that a couple of coats of gloss varnish, just to add that little bit extra to it.

Link to comment
Share on other sites

  • 3 months later...

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.