Jump to content

Sculpting a Daemon hand.


Lazarus666

Recommended Posts

Hello fellow brethren's.

 

I thought that i should share some of my knowledge with you all and post a tutorial for the first time

on these boards. And bear with my spelling, i am not a native english speaker. :P

 

Things needed:

 

Toothpick('s)

GW sculpting tool

Lubrication ( used Vaseline )

Greenstuff

 

In every step i use the gw tool and the lubricant to smooth the gs, and i always keep the toothpick lubricated too.

 

Step 1

 

Take an appropriate sized lump of greenstuff. This was a leftover from when i did some sculpting on my lord.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/1.jpg

 

Step 2

 

Shape the lump a bit like a hand, or rather a paw shape actually.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/2.jpg

 

Step 3

 

Now take your toothpick and make a hole in each of the "finger" spots.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/3.jpg

 

Step 4

 

Take smaller piece of gs..

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/4.jpg

 

Step 5

 

Roll the gs to a cylinder, and then start rolling only at one of the edges...

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/5.jpg

 

Step 6

 

Until it becomes a cone-like shape.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/6.jpg

 

 

Step 7

 

Cut the cone at a good length.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/7.jpg

 

 

Step 8

 

Attach the cone to one of the sockets on the hand.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/8.jpg

 

Step 9

 

Bend the cone with a smooth tool.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/9.jpg

 

Repeat step 4-9 until all the sockets are filled.

 

Step 10

 

With a little poking around to style the hand it can end up like this.

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Claw%20tutorial/10.jpg

 

 

And here is how it can look applied to a model.

 

http://i592.photobucket.com/albums/tt5/Inquizarus/Nurgle/Lord/DSC00269.jpg

Link to comment
Share on other sites

I like it a lot.

 

It's fast, simple and gets you good results.

 

I especially like how you used it to build the fanged mouth onto the chest plate and the shoulder pad.

 

Let's hope some Librarium staff shows up and asks you if you want it up there. I think it's definitely worth it! ^^

Link to comment
Share on other sites

  • 2 weeks later...

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.